Design a simple annular flow heat exchanger. Assume both fluids are water and the cold fluid flowing in the outer tube. The pipe diameters are basedâ€¦ | Cheap Nursing Papers

Design a simple annular flow heat exchanger. Assume both fluids are water and the cold fluid flowing in the outer tube. The pipe diameters are based in type L copper tube with dimensions: (outside diameter 1/2-inch, nominal tube is 0.625 inch, with a wall thickness of 0.04 inches and the outside diameter of the one-inch nominal tube is 1.125 inches with a wall thickness of 0.05 inches. The mass flow-rate of water through both tubes should be based on 10 ft/s of water. The inlet temperature to the cold side is 40 degree F and the inlet to the hot side is 90 degree F. what length of heat exchanger is required to achieve a hot-side outlet temperature of 60 degree F if the overall heat transfer coefficient (U) for the heat exchanger is 400 Btu/hr.ft^2 F. Also calculate the log mean difference and effectiveness.

Hi there! Click one of our representatives below and we will get back to you as soon as possible.

Chat with us on WhatsApp